RHS 180×100×7.1 vs CF RHS 180×100×8
RHS 180×100×7.1 is an RHS Hot-finished section from the UK Blue Book (SCI P363); CF RHS 180×100×8 is the closest equivalent in the UK Blue Book (SCI P363). CF RHS 180×100×8 carries more bending: 226 cm³ of plastic modulus against 215 cm³, 4.9% more. RHS 180×100×7.1 is the lighter of the two at 29.2 kg/m against 31.4 kg/m, a saving of 7.0% on steel weight. Both are about 180 mm deep, so either fits the same construction zone.
| Property | RHS 180×100×7.1 RHS Hot-finished | CF RHS 180×100×8 RHS Cold-formed | Difference |
|---|---|---|---|
| Mass | 29.2 kg/m | 31.4 kg/m | -7.0% |
| Depth | 180 mm | 180 mm | same |
| Width | 100 mm | 100 mm | same |
| Web thickness | 0 mm | 0 mm | same |
| Flange thickness | 0 mm | 0 mm | same |
| Area | 37.2 cm² | 40 cm² | -7.0% |
| Second moment, major (Iy) | 1,560 cm⁴ | 1,600 cm⁴ | -2.5% |
| Plastic modulus, major (Wpl,y) | 215 cm³ | 226 cm³ | -4.9% |
| Elastic modulus, major (Wel,y) | 173 cm³ | 178 cm³ | -2.8% |
| Second moment, minor (Iz) | 613 cm⁴ | 637 cm⁴ | -3.8% |
| Plastic modulus, minor (Wpl,z) | 142 cm³ | 150 cm³ | -5.3% |
| Radius of gyration, minor (iz) | 4.06 cm | 3.99 cm | +1.8% |
| Torsion constant (It) | 1,410 cm⁴ | 1,570 cm⁴ | -10.2% |
RHS 180×100×7.1 to BS EN 10210-2:2006; CF RHS 180×100×8 to BS EN 10219-2:2006. Difference is expressed relative to CF RHS 180×100×8.
How to choose between them
On stiffness, CF RHS 180×100×8 has the larger second moment of area: 1,600 cm⁴ against 1,560 cm⁴, a difference of 2.5%. This matters more often than the strength comparison, because on normal floor spans deflection rather than bending capacity sets the beam size - so if the two are close on modulus but apart on inertia, the stiffer one is usually the better answer even when it is not the stronger one.
Measured as bending capacity per kilogram of steel, RHS 180×100×7.1 is the more efficient section: 7.4 against 7.2 cm³ per kg/m, 2.3% better. Over a floor of repeated beams that difference is real tonnage, though it is often outweighed by whichever section the fabricator can actually source.
In short, CF RHS 180×100×8 is the stronger section and RHS 180×100×7.1 is the lighter one; where those are the same section, it is the clear choice, and where they are not, decide on whether your design is governed by capacity or by tonnage.