UB 457×152×52 vs W 18X35
UB 457×152×52 is an UB section from the UK Blue Book (SCI P363); W 18X35 is the closest equivalent in the American AISC Shapes Database. They are close to interchangeable in bending: 1100 cm³ against 1089.7 cm³ of plastic modulus, a difference of 0.9%. They weigh essentially the same, 52.3 kg/m and 52.1 kg/m. Both are about 450 mm deep, so either fits the same construction zone.
| Property | UB 457×152×52 UB | W 18X35 W | Difference |
|---|---|---|---|
| Mass | 52.3 kg/m | 52.1 kg/m | +0.4% |
| Depth | 449.8 mm | 449.6 mm | same |
| Width | 152.4 mm | 152.4 mm | same |
| Web thickness | 7.6 mm | 7.6 mm | same |
| Flange thickness | 10.9 mm | 10.8 mm | +0.9% |
| Area | 66.6 cm² | 66.5 cm² | +0.2% |
| Second moment, major (Iy) | 21,400 cm⁴ | 21,228 cm⁴ | +0.8% |
| Plastic modulus, major (Wpl,y) | 1,100 cm³ | 1,089.7 cm³ | +0.9% |
| Elastic modulus, major (Wel,y) | 950 cm³ | 943.89 cm³ | +0.6% |
| Second moment, minor (Iz) | 645 cm⁴ | 636.8 cm⁴ | +1.3% |
| Plastic modulus, minor (Wpl,z) | 133 cm³ | 132.08 cm³ | +0.7% |
| Radius of gyration, minor (iz) | 3.11 cm | 3.1 cm | +0.3% |
| Torsion constant (It) | 21.4 cm⁴ | 21.06 cm⁴ | +1.6% |
UB 457×152×52 to BS EN 10365:2017; W 18X35 to AISC Shapes Database v16.0. Difference is expressed relative to W 18X35.
How to choose between them
On stiffness, UB 457×152×52 has the larger second moment of area: 21,400 cm⁴ against 21,228 cm⁴, a difference of 0.8%. This matters more often than the strength comparison, because on normal floor spans deflection rather than bending capacity sets the beam size - so if the two are close on modulus but apart on inertia, the stiffer one is usually the better answer even when it is not the stronger one.
Measured as bending capacity per kilogram, the two are equally efficient (21.0 against 20.9 cm³ per kg/m), so on a pure steel-tonnage basis there is nothing to choose between them. The decision comes down to availability, connection detailing and what the rest of the frame uses.
These come from different catalogues, so treat the swap as a design change rather than a like-for-like substitution. UB sections are specified to BS EN 10365:2017 and W to AISC Shapes Database v16.0; the steel grades, tolerances and available lengths differ, connection details and bolt gauges are set out differently, and the two are rarely both stocked in the same market. Check availability before changing a section on a drawing to save a marginal amount of weight.
In short, these two are genuine equivalents. Pick whichever your supplier stocks and the rest of the frame already uses.