HSS 30X10X7-8 - Section Properties

HSS 30X10X7-8 has a mass of 221.06 lb/ft (329 kg/m), tabulated to AISC Shapes Database v16.0. A 12 m length therefore weighs about 3948 kg, which is the figure to use for a steel take-off or when checking a lift.

HSS 30X10X7-8 has a depth of 30 in (762 mm), a width of 10 in (254 mm), a web thickness of 0.814 in (20.7 mm), a wall thickness of 0.814 in (20.7 mm), with a cross-sectional area of 60.8 in² (392.3 cm²). These are the nominal dimensions from AISC Shapes Database v16.0; rolling tolerances apply to the delivered section.

The plastic section modulus about the major axis, Wpl,y, is 8,849 cm³, and the elastic modulus Wel,y is 6,767.9 cm³. Wpl,y is what sets the moment capacity of a Class 1 or 2 section: M_pl,Rd = Wpl,y x f_y / gamma_M0, so at S355 with gamma_M0 = 1.0 this section reaches about 3141 kNm before any stability check.

The second moment of area about the major axis, Iy, is 257,647 cm⁴, and about the minor axis Iz is 44,537 cm⁴. Iy is the value deflection depends on - for a simply supported beam under a uniform load, the midspan deflection is 5wL⁴/384EIy - so on spans where a deflection limit governs rather than strength, this is the number that decides the section.

iy is 25.65 cm about the major axis and iz is 10.67 cm about the minor axis. Column buckling is governed by the SMALLER value: the slenderness is lambda = L_cr / i, so with iz = 10.67 cm a 1.1 m effective length already gives lambda = 100. Minor-axis buckling almost always controls unless the weak axis is restrained.

The St Venant torsion constant It is 129,448 cm⁴. Closed sections carry torsion in a shear flow around the perimeter, which makes them far stiffer in torsion than an open section of the same weight and is usually why one is specified.