SHS 16×16×1.6 - Section Properties

SHS 16×16×1.6 has a mass of 0.699 kg/m, tabulated to EN 10219. A 12 m length therefore weighs about 8 kg, which is the figure to use for a steel take-off or when checking a lift.

SHS 16×16×1.6 has a depth of 16 mm, a width of 16 mm, a wall thickness of 1.6 mm, with a cross-sectional area of 0.856 cm². These are the nominal dimensions from EN 10219; rolling tolerances apply to the delivered section.

The plastic section modulus about the major axis, Wpl,y, is 0.449 cm³, and the elastic modulus Wel,y is 0.354 cm³. Wpl,y is what sets the moment capacity of a Class 1 or 2 section: M_pl,Rd = Wpl,y x f_y / gamma_M0, so at S355 with gamma_M0 = 1.0 this section reaches about 0 kNm before any stability check.

The second moment of area about the major axis, Iy, is 0.284 cm⁴, and about the minor axis Iz is 0.284 cm⁴. Iy is the value deflection depends on - for a simply supported beam under a uniform load, the midspan deflection is 5wL⁴/384EIy - so on spans where a deflection limit governs rather than strength, this is the number that decides the section.

iy is 0.576 cm about the major axis and iz is 0.576 cm about the minor axis. Column buckling is governed by the SMALLER value: the slenderness is lambda = L_cr / i, so with iz = 0.576 cm a 0.1 m effective length already gives lambda = 100. Minor-axis buckling almost always controls unless the weak axis is restrained.

The St Venant torsion constant It is 0.498 cm⁴. Closed sections carry torsion in a shear flow around the perimeter, which makes them far stiffer in torsion than an open section of the same weight and is usually why one is specified.