FB 16×200 - Section Properties

FB 16×200 has a mass of 25.12 kg/m, tabulated to EN 10058. A 12 m length therefore weighs about 301 kg, which is the figure to use for a steel take-off or when checking a lift.

FB 16×200 has a depth of 200 mm, a width of 16 mm, a wall thickness of 16 mm, with a cross-sectional area of 32 cm². These are the nominal dimensions from EN 10058; rolling tolerances apply to the delivered section.

The plastic section modulus about the major axis, Wpl,y, is 160 cm³, and the elastic modulus Wel,y is 106.7 cm³. Wpl,y is what sets the moment capacity of a Class 1 or 2 section: M_pl,Rd = Wpl,y x f_y / gamma_M0, so at S355 with gamma_M0 = 1.0 this section reaches about 57 kNm before any stability check.

The second moment of area about the major axis, Iy, is 1,067 cm⁴, and about the minor axis Iz is 6.827 cm⁴. Iy is the value deflection depends on - for a simply supported beam under a uniform load, the midspan deflection is 5wL⁴/384EIy - so on spans where a deflection limit governs rather than strength, this is the number that decides the section.

iy is 5.77 cm about the major axis and iz is 0.462 cm about the minor axis. Column buckling is governed by the SMALLER value: the slenderness is lambda = L_cr / i, so with iz = 0.462 cm a 0.0 m effective length already gives lambda = 100. Minor-axis buckling almost always controls unless the weak axis is restrained.