FB 9×150 - Section Properties

FB 9×150 has a mass of 10.6 kg/m, tabulated to EN 10058. A 12 m length therefore weighs about 127 kg, which is the figure to use for a steel take-off or when checking a lift.

FB 9×150 has a depth of 150 mm, a width of 9 mm, a wall thickness of 9 mm, with a cross-sectional area of 13.5 cm². These are the nominal dimensions from EN 10058; rolling tolerances apply to the delivered section.

The plastic section modulus about the major axis, Wpl,y, is 50.63 cm³, and the elastic modulus Wel,y is 33.75 cm³. Wpl,y is what sets the moment capacity of a Class 1 or 2 section: M_pl,Rd = Wpl,y x f_y / gamma_M0, so at S355 with gamma_M0 = 1.0 this section reaches about 18 kNm before any stability check.

The second moment of area about the major axis, Iy, is 253.1 cm⁴, and about the minor axis Iz is 0.911 cm⁴. Iy is the value deflection depends on - for a simply supported beam under a uniform load, the midspan deflection is 5wL⁴/384EIy - so on spans where a deflection limit governs rather than strength, this is the number that decides the section.

iy is 4.33 cm about the major axis and iz is 0.26 cm about the minor axis. Column buckling is governed by the SMALLER value: the slenderness is lambda = L_cr / i, so with iz = 0.26 cm a 0.0 m effective length already gives lambda = 100. Minor-axis buckling almost always controls unless the weak axis is restrained.