CHS 244.5×14.2 - Section Properties

CHS 244.5×14.2 has a mass of 80.6 kg/m, tabulated to BS EN 10210-2:2006. A 12 m length therefore weighs about 967 kg, which is the figure to use for a steel take-off or when checking a lift.

CHS 244.5×14.2 has a depth of 244.5 mm, a width of 244.5 mm, a wall thickness of 14.2 mm, with a cross-sectional area of 103 cm². These are the nominal dimensions from BS EN 10210-2:2006; rolling tolerances apply to the delivered section.

The plastic section modulus about the major axis, Wpl,y, is 754 cm³, and the elastic modulus Wel,y is 559 cm³. Wpl,y is what sets the moment capacity of a Class 1 or 2 section: M_pl,Rd = Wpl,y x f_y / gamma_M0, so at S355 with gamma_M0 = 1.0 this section reaches about 268 kNm before any stability check.

The second moment of area about the major axis, Iy, is 6,840 cm⁴, and about the minor axis Iz is 6,840 cm⁴. Iy is the value deflection depends on - for a simply supported beam under a uniform load, the midspan deflection is 5wL⁴/384EIy - so on spans where a deflection limit governs rather than strength, this is the number that decides the section.

iy is 8.16 cm about the major axis and iz is 8.16 cm about the minor axis. Column buckling is governed by the SMALLER value: the slenderness is lambda = L_cr / i, so with iz = 8.16 cm a 0.8 m effective length already gives lambda = 100. Minor-axis buckling almost always controls unless the weak axis is restrained.

The St Venant torsion constant It is 13,700 cm⁴. Closed sections carry torsion in a shear flow around the perimeter, which makes them far stiffer in torsion than an open section of the same weight and is usually why one is specified.