Hem-Fir, No. 2 - Design Values
Hem-Fir, No. 2 is a dimensional lumber grade with reference design values to NDS 2018 Supplement Table 4A. Its reference bending value Fb is 850 psi, compression parallel Fc is 1,300 psi, and modulus of elasticity E is 1,300,000 psi (NDS). Values are shown before adjustment factors; apply the relevant NDS C-factors or EC5 k_mod and γ_M for your load case.
| Fb | Bending | 850 psi |
| Ft | Tension parallel | 525 psi |
| Fv | Shear parallel | 150 psi |
| Fc⊥ | Compression perpendicular | 405 psi |
| Fc | Compression parallel | 1,300 psi |
| E | Modulus of elasticity | 1,300,000 psi |
| Emin | Modulus for stability | 470,000 psi |
| G | Specific gravity | 0.43 |
| Nominal | Actual (in) | Metric (mm) |
|---|---|---|
| 2x4 | 1.5 x 3.5 | 38 x 89 |
| 2x6 | 1.5 x 5.5 | 38 x 140 |
| 2x8 | 1.5 x 7.25 | 38 x 184 |
| 2x10 | 1.5 x 9.25 | 38 x 235 |
| 2x12 | 1.5 x 11.25 | 38 x 286 |
Source: NDS 2018 Supplement Table 4A. Reference values are shown before adjustment factors (NDS C-factors / EC5 k_mod, γ_M) - apply these per your load case in design.
Understanding these values
For a beam in Hem-Fir, No. 2, bending at Fb 850 psi normally sets the size, but the check that actually governs depends on the span. Short heavily loaded members are often limited by shear at Fv 150 psi, and bearing at a support is limited by compression perpendicular to grain at Fc perp 405 psi, which is the lowest of the strength values and the one most often overlooked. Used as a post or stud, the governing value is compression parallel at Fc 1,300 psi.
Stiffness for Hem-Fir, No. 2 is E 1,300,000 psi, with the reduced modulus Emin 470,000 psi used for stability calculations such as the beam stability factor CL and the column stability factor CP. On typical floor spans, deflection rather than strength decides the section, so compare E before Fb when the member is a joist. Its specific gravity of 0.43 is the value connection design works from, not the strength figures.
Within the dimensional lumber entries in this catalogue, Hem-Fir, No. 2 ranks 11 of 13 on bending at 850 psi; the strongest listed is Southern Pine, Select Structural at 2,550 psi. Grade choice is usually a trade of cost against section depth, so it is worth checking whether a lower grade in a deeper section is cheaper than a higher grade at the depth you started with.
The closest alternative in the same family is Spruce-Pine-Fir, No. 1/No. 2 at 875 psi in bending, 3% above this grade. If availability drives the choice rather than capacity, that is the substitution to price first - but re-run the deflection check as well, because stiffness and strength do not always move together.